How to use an automatic wire stripping machine?

　　一. Preparation

　　Before operating the machine, make sure everything is properly set up.

　　1. Check the Equipment

　　Ensure the power, wires, and air tubes are connected correctly.

　　Make sure the blades are sharp and securely tightened.

　　Verify the machine is in “standby” mode.

　　2. Set the Parameters

　　Wire length: Enter the total cutting length required.

　　Strip length: Set the stripping length for both the front and rear ends.

　　Wire size: Adjust the blade opening according to the wire diameter.

　　Cutting length: (For automatic cutting models) Input the desired cutting length.

　　3. Run a Test Sample

　　Insert a sample wire and run a test strip.

　　Check if the insulation is completely removed without damaging the copper strands.

　　Finetune the blade depth or strip length if necessary.

　　️ 二. Operating Steps

　　1. Feed the Wire

　　Insert the wire through the wire guide and align it with the feeding rollers.

　　Make sure the wire is straight and properly positioned.

　　2. Start the Machine

　　Press the “Start” button or use the foot pedal to begin automatic feeding and stripping.

　　For fully automatic machines, the system will complete cutting, stripping, and segmenting in one cycle.

　　3. Collect the Finished Wires

　　Check if the stripped length and exposed conductor are consistent.

　　Make sure the copper strands are not damaged or pulled.

　　三. Important Safety Tips

　　Adjust blade depth and speed based on wire type (PVC, Teflon, silicone, etc.).

　　Never place your hands near the blade area while operating.

　　Clean wire scraps and inspect blades after each workday.

　　Apply a small amount of lubricant to guide rails and bearings regularly for smooth performance.